Edge Autolocate-Modus

Garmin fenix 7X und epix Gen 2 im Test

Der Schwerpunkt dieses Tests und Vergleichs der Garmin Fenix 7X Solar und Garmin Epix Gen 2 liegt auf den Sensoren wie Höhenmesser, Positionsbestimmung und Herzfrequenz. Was unterscheidet die beiden GPS-Outdoor-Smartwatches? Und wie gut ist die Taschenlampe der Fenix 7X für den Outdoorbereich? Hier geht es zum Test der Outdoor-Smartwatches ...

    Hallo,
    Seit kurzem habe ich den Edge 305.
    In der History der Firmware-Updates ist beschrieben wie man das Gerät in den Autolocate-Modus versetzt:

    Changes from 2.30 to 2.40
    Improved Courses to function off of location based logic. When doing a Course the user
    is now matched to a position along the Course based on location and heading. Allows
    users to join Courses at any point during their ride and have the Course synchronized
    to their position.
    Changed to allow Autolap in Courses.
    Show Compass page with guidance when doing a Course.
    Add 'Distance to Next' and 'Time to Next' fields on the Compass page.
    Disabled redundant Alerts during Workouts.
    Keep GPS page in page loop if there is no GPS fix.
    Allow editing of the position and elevation when marking a location.
    Add ability to find nearest locations and to delete all.
    Add ability to put GPS in Autolocate mode by holding DOWN when powering on.
    Add quick settings lists to Quick Workout setup.
    Add Warmup and Cooldown to Interval Training feature.
    Seperated the distance and elevation units setup values.
    Fix problem that could occur on workout lists from too many Workouts or Workout Steps.
    Fix problem where calories would sometimes not reset after upload to Training Center.
    Fix problem with distance not updating and track not recording if unit was powered
    down while plugged into USB, and then powered back on without ever being disconnected.
    Fix problem with Autopause not working when set to 0 or stopped.
    Fix problem with potential slowdown and lockup on Altimeter page.
    Fix problem with reporting invalid cadence values when sensor not present.
    Added support for nRoute.
    Added Slovakian and Slovenian Languages.
    Updated translations.
    Fix problem where multiple cadence sensors not being stored off for separate bike profiles.
    Power off USB pins when not connected.
    ------------------------------------------------------------

    Dies gelingt mir aber nicht.
    Nur eher zufällig sagt das Display mal "Orte Satelliten" statt "Erfasse Satelliten".

    Kann jemand mal testen ob die beschriebene Tastenkombination bei seinem Gerät funktioniert?

    Meine Firmware ist auf Stand 2.90, und auch der Chipsatz ist auf neustem Stand.

    Danke und Frohes Neues.

    Klaus